The D21-PS electronic controller has been designed to take full advantage of our patented Air-Flow Sensor which modulates the heater’s capacity according to the quantity of air flowing through the heater by responding to the radiant heat of the elements even at very low CFMs. With normal airflow the controller will operate at full power. When the airflow drops below the minimum airflow, the controller will still operate but at reduced power. It will also safely shut down the heater in case of a total loss of airflow. D21-PS controllers may be used to drive up to 4 SSRs. The maximum load is limited to the capacity of the Solid State Relays. In cases with smaller loads, consider the D21-P with a single output and the D22-P equipped with two outputs effectively doubling the capacity of the D21-P. The ‘P’ versions of controllers such as D21-P, D22-P and D21-PS operate with an input signal of 0 - 10 VDC or AC/DC pulse. It is also possible to adapt the wiring to use a simple ON/OFF contact to turn the controller full on and off. To switch the input between 0-10 VDC and AC/DC pulse, simply remove and replace the jumper according to the label.
Mercury contactors are used for stage switching. Advantages: silent operation. Exceptionally reliable. Long life expectancy (Tested for 1,000,000 cycles) Note: Mercury contactors are position sensitive, hence it is important to specify in which position the heater is to be instal...Learn More
Duct sensor The DS-600 is a thermistor based duct sensor designed to work with Thermolec’s thermostats and electronic controllers to modulate the heater’s capacity according to the heat required. In most cases the DS-600 is used with Thermolec’s 0-10 VDC Room Thermostat to allow...Learn More
The automatic reset thermal cut-out is a fixed temperature disc type safety device that opens the control circuit when it’s set point is reached. It automatically resets and returns the heater to operating conditions when the overheating conditions have disappeared.Learn More
2060 Lucien Thimens
H4R 1L1 map